May 19, 2011

Luminara's headgear- The dome


I realized yesterday that Desucon is only a month away. Inspired or horrified of the closing convention I started with Luminara’s headgear. I dug up the base I had prepared in February as a refreshing crafting project between Snowtrooper’s construction. The materials I used for the dome part was corrugated cardboard, lots of masking tape, modelling “clay”, tricot and flannel for support and padding and wool.


I took advantage on our Snowtrooper helmet dome mold for the cardboard skeleton. I actually had done one dome before, but because I didn’t have anything to shape it over it became too big and bulky for my taste. With the mold I was able to get the shape close enough and with little tweaking and trying it on it finally took nice, fitting form. I used hot glue and masking tape to keep the structure together.


Next I took about 250 grams of modelling material and rolled it to thin sheet. Then I covered the dome with the clay substitute. Then I left the dome to dry before the next step. After the clay is dry, it’s almost impossible to alter the shape anymore. The cardboard dome was correct size for me, but it was bit too round while my head is more oval. I padded my wig head with plastic to fit my head size and taped the sides down to create the right shape on the rim.


After the clay was dry I covered the dome with tricot and applied glue-water mixture all over. The tricot smoothed out some of the inconsistencies in the clay and because I was too lazy to sand it I added flannel on the front to hide all the remaining bumps. I only applied glue on the edges to keep the fabric soft. I also didn’t cover the whole dome, because the back part will not be visible under the, uh, curtain..?


I had bought the only brown wool with smooth surface available on the local fabric stores. Not the best time of the year to buy wool, I say. I stretched the fabric over the dome and added water to where I had to stretch even more. Damp wool will stretch nicely and with little effort, but will not revert as a warning to the aspiring hat makers out there.

I haven’t lined the dome yet. I’m still thinking will the hat need some support system or elastics inside. To write this post I took a break from trying to figure how the shape of the, emm, curtain structure on the top is achieved. I’ve tried three different methods this far and I think it’s time to move on to mesh-wire-paper clay- direction.

Oh yeah, I finished the brooch! At least something is ready!

I could've take a photo of the finished thing with missing rings and attachment... Oh, well.